GOEDE stainless steel sand casting cope and drag frame units O.D. 10"x15"x6.75"

Description

Light weight and strong at only 7 pounds of strong non corrosive stainless steel.
Engineered for maximum efficiency and versatility.
There is A 1/2" lip inward on all top and bottom surfaces designed to insure the sand stays in the form and not on the floor
This 1/2" lip also allows for you to insert and remove bottom panels of your choice for top press imprint of parts.
The side rails  allow for good grip when moving and lifting the top or both units at the same time.
The alignment strips make it very easy to remove and replace the top unit
Works with oil and water based casting sand.
Workable sand impression area is 8.75" x 13.75"
Depth of the top and/or bottom unit is just over 3"