Large Hammer or Ax Drift for Blacksmiths & Knifemakers

Description

Our Large Blacksmiths hammer drift is approx. 11" long and is oval shaped to form the hole needed to handle most handmade hammers,axes and tomahawks etc. It is a very good size for hammer 2-1/2 lb and greater heads. The
tool measures 5/8 x 3/4 at the small end and tapers up to 7/8 x 1" at the large end which offers
flexibility
in hole size choice.
The process used by most smiths is to drill a series of small holes as close together in the center of the workpiece to be drifted. Once the holes are drilled heat the item and use a cold chisel or similar tool to split the piece.
(Check the chisels from  "Pieh Tool. There is a good one from Peddinghaus of Chrome Moly)
Once split, heat the piece again and drive the drift through the hole.
Tap the sides of the workpiece while continuing to drive the drift into the workpiece until the drift hole gets to the desired measurement.
The process of heating may be needed several times to get the desired shape.
The tool is made of tough 60/45 ductile iron. We have produced these castings for many years and they have proven usefulness and reliability.
Please look at my other auctions as well by visiting the store. All tools are new and in very good condition.
Casting weighs approx. 2 lbs.
Made in the USA!